ULTIMATE FAST GROUT SEAL
Spray-on Grout Sealer for Floors, Wall, Backsplashes, and More
PLAY VIDEO TO LEARN MORE
Will 'Hold' the newly installed grouts color from fading out and allow the fresh grout to cure harder and stronger.
THE ULTIMATE GROUT SEALER WHERE YOU JUST SPRAY AND WALK AWAY!
Can be applied to damp/uncured grout immediately after grouting and will keep the grouts color from fading while drying. Leaves no hard-to-remove residue, it penetrates to protect grout, stone and masonry surfaces against both oil and water-based stains and will not change the surface appearance. Also great for use on cleaned, existing grout as well.
The Convenience and Ease of ULTIMATE GROUT SEALER
For Multiple Floors and Surfaces!
Works on Ceramic & Porcelain Tile Grout, Travertine, Marble, Granite, Limestone, Slate, and more.
Specially designed spray tip allows for pin-point application onto grout joints, giving up to 4X more coverage per can and no messy residue to clean up compared to competitors.
EXPECTED WEAR UP TO 25 YEARS
EASY TO USE AND APPLY
SEAL IMMEDIATELY AFTER GROUTING!
- JUST SPRAY AND WALK AWAY
- GROUT COLOR WON'T FADE WHEN APPLIED TO FRESH GROUT
- NO CLEAN-UP
- 800 - 1,000 LINEAR FEET
EXPECTED WEAR UP TO 25 YEARS!*
Can be applied to damp/uncured grout immediately after grouting and will keep the grout color from fading while drying and leaves no hard-to-remove residue. Can also be used with clean, existing grout as well. Will not change surface appearance. It penetrates to protect grout, stone and masonry surfaces against both oil and water-based stains.
* This will vary depending on type of surface, wear and proper maintenance. This is not a warranty.
ADVANCED Products Means Buying the Highest Quality Sealers and Cleaners on the Market Today.
DIRECTIONS
KEEP OUT OF THE REACH OF CHILDREN
Always test product in an inconspicuous area to determine suitability for intended use. Suitability for a particular purpose is always the responsibility of the user.
- Make sure that the surface is thoroughly clean and free from waxes, sealants, or coatings of any kind. Protect acrylic or stained surfaces such as cabinets from overspray when using this product.
- Shake well. Spray 10-16 inches from surface. Apply product evenly. Wipe off excess if spraying vertical areas.
- Allow to cure for 24 hours. Test after application using water droplets, if droplets are absorbed, a second or third coat may be necessary to attain the desired performance. Dries to the touch in about one (1) hour at 75°F. Use only in well ventilated areas. Open windows and use fans to circulate air. It is always recommended that gloves, goggles and NIOSH approved respirator are worn at all times.
